If you don’t have a hole in the top of the propeller, you can still feed the floss in from the bottom before you put it on. This technique is great for most push-on props, which are used from the smallest micro quads up to about the 2” size. You don’t want the extra floss getting wrapped up inside. The most important part to cut cleanly is the bottom, near the motor. The thin scissors in inexpensive tool kits like the HDT RC Tool Set work really well for this, but a thin hobby knife can work well, too. Get your scissors or knife in as close to the prop as possible to trim off the excess floss. If it’s still really loose, you can try adding two pieces. You’ll notice how the floss adds some extra friction to the fit. For props with a hole all the way through, threading it from the top side is usually easier.
Take a short piece of floss and thread it into the hole where the prop shaft will go. If you find that a prop is stuck on tightly, just leave it alone-you won’t need to perform this fix for that prop and motor combination! You probably won’t have too much trouble with this step if you’re already having issues with the props coming off in flight. Be careful not to bend the blades this can happen pretty easily with these small props. (You can wait until they fall off on their own, but then you may not find them again.) I still like using the prop tools that came with early micro quads, but a pair of tweezers can do the trick. In this article we’ll be fixing the Meteor65, and this technique works for all sorts of small props and craft. For tools, a thin pair of scissors work best-but you can also use a hobby knife. What you’ll need for this fix is found in most households: dental floss. There is a simple solution for this that works with most whoop props. Even worse, they can become choking hazards for small children. There’s the cost as well, and the shipping time and availability. Of course not being able to fly is annoying-but maybe your micro didn’t come with spare props, or maybe you’ve lost them all. The prop tends to fly off to parts unknown, inevitably blending in with the rug or burying itself behind something that’s hard to get underneath if you can find it at all. Do you have a whoop that keeps throwing props? Here’s how to fix it.Ī lot of micro quads have a similar problem: whenever they crash, they tend to lose a prop or two.
0 kommentar(er)
